However, using an Allen-Bradley motor with your drive removes the . Н Installation guidelines called out in Appendix D of the User’s Manual. Installation Instructions IN. May, Allen-Bradley. Dynamic Brake. Cat. No. KAA KBA03, KBA06, KBA Table of Contents. Find great deals for Allen Bradley Adjustable Frequency AC Drive User Manual. Shop with confidence on eBay!.
|Published (Last):||16 October 2005|
|PDF File Size:||20.83 Mb|
|ePub File Size:||15.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
An external pot is connected and the ground lead of the pot is disconnected, creating a potential drive overspeed hazard. Phase W Fault – F40 A phase to ground fault has been detected between the drive and motor in this phase. Error 2 – The number of parameters in saved profile does not equal master number.
1305 AC Drives
Hz Err Fault – F29 No valid operating frequency. If the motor is drawing excessive current, the motor load is excessive and will not allow the drive to accelerate to set speed.
If not, manually program any remaining parameters. Check motor for grounded phase.
Open Pot Fault – F9 An external pot is connected and the ground lead of the pot is disconnected, creating a potential drive overspeed hazard. An attempt has been made to set the [Run Boost] parameter to a value greater than the [Start Boost] parameter.
No valid operating frequency. Inspect the wiring between the drive and motor.
bradlfy The last parameter programmed will be displayed on the top line. Check the motor for grounded phase. Bus overvoltage can also be caused by motor reeneration. Correct the cause of the fault and manually clear by cycling the stop command or cycling power. Stop drive, then re-run download. Reprogram Fault – F48 May occur when drive parametersare reset to default settings. Reduce [Start Boost] if applicable.
Connect proper adapter or change active frequency source. Replace the Communication cable. Error 5 – Drive is running while attempting download. Overtemperature Fault – F8 Temperature sensor detects excessive heat. Overload Fault – F7 Internal electronic overload trip. Alen for proper mounting and spacing.
Unplug the HIM from the cable or drive and reconnect it. Motor Stall Fault – F6 The motor has stalled If manuall motor is drawing excessive current, the motor load is excessive and will not allow the drive to accelerate to set speed. Inspect fault buffer for fault code requiring reset. Check [Minimum Freq] and [Maximum Freq] parameters.
Press Enter to continue download.
Allen Bradley Adjustable Frequency AC Drive User Manual | eBay
Reset your drive to the factory default settings. DC Braking cannot be used with a synchronous motor. Reset to Default Parameters and Cycle power. Check programming of [Curr Lim Trip En] parameter. Check the AC line for high line voltage or transient conditions. Inspect to ensure that the ambient temperature limit has not been exceeded.
Inspect for breaks in communications line. Drive Reset Fault – F22 May occur on power-up. Phase U Fault – F38 Brad,ey phase to ground default has been detected between the drive and motor in this phase.
Allen Bradley 1305 Adjustable Frequency AC Drive User Manual
Error 3 – Download was mnual to a different type drive i. An active local bus adapter is disconnected while it possesses control of a local bus function.
Fast repairs at low costs. Error 4 – Saved data for parameter not correct for new drive.
Extend the deceleration time or instal dynamic brake option. Verify that the parameter has been programmed correctly.